A very good traditional Irish stout made with chocolate malt.
Preparation Time
2 hr
Cooking Time
60 mins
Total Time
3 hr
Calories
308 Calories
Recipe Instructions
Step 1
Pour 3 gallons of water into a large stainless steel pot. Heat to 130 degrees F (55 degrees C). This works best using an outdoor propane burner from a turkey fryer, but you can also use your stove. Add 1 teaspoon gypsum, English malt, chocolate malt, roasted barley and black patent malt in a nylon steeping bag. Steep for 30 minutes, maintaining the temperature.n
Step 2
After 30 minutes, increase the heat to 152 degrees F (65 degrees C). Steep for 60 minutes, maintaining a constant temperature. Remove grains to a separate pot to drain and bring the wort to a boil. Rinse the grains with water of the same temperature and pour the liquid into the pot. Stir in the dry malt extract and 1 teaspoon of gypsum. Return to a boil and add the Fuggles hops; set a timer for 60 minutes. When there are 15 minutes left, add the Irish moss. When 10 minutes are left, add the Willamette hops.n
Step 3
About the same time as you add the Irish moss and final hops, prepare an ice bath by filling a sink, large tub or cooler with ice. When the time is up, remove the pot from the heat, cover and place in the ice bath. Be careful not to drop anything into the pot that is not sterilized, including spoons. Cool your wort to 68 degrees F (20 degrees C). You can swirl around the ice bath to help it cool.n
Step 4
Meanwhile, dissolve the yeast in 1 cup of water (70 degrees F) and let it stand until ready to use. This will help to keep from shocking your yeast and ensure a faster start of the fermentation.n
Step 5
Strain the wort into a sterile fermenter (carboy) and add the yeast. Add enough bottled or boiled and cooled water to reach the 5 1/2 gallon mark, about 1 1/2 more gallons. Seal with a cap and shake or rotate to mix in the yeast. Replace the cap on the fermenter with an airlock and place in a cool dry place where the temperature remains consistently below 70 degrees F (21 degrees C). Ferment for 7 days or until it stops foaming.n
Step 6
Use a sterile siphon hose to transfer the beer to a secondary fermenter. Set in a place where the temperature is 64 degrees F (17 degrees C). Cap with the airlock and ferment for 14 days, or until the specific gravity has dropped to 1.005 when tested using a hydrometer or does not change for several days.n
Step 7
Sterilize your bottles for bottling. Pour the beer into a new sterile 5 gallon bucket and stir in the corn sugar until dissolved. Siphon into sterile bottles and cap. Let the beer prime in the bottle for at least 14 days in a place where the temperature stays below 70 degrees F (21 degrees C).n
